Central Controller (Es-Med) Operation - BeaconMedaes dMED 7 Instruction Book

• Dryer/compressor selection (ES_3): enables the user to view the compressor/dryer submenu.
• Compressor overview screen (ES_4): shows an overview of the compressors of the plant with their status.
In the example shown, we can see that compressor 1 is running and will be the next to stop, while
compressor 2 is stopped and will be the next to start.
• Command screen (ES_5): enables the user to start the central controller or force the compressors into local
mode.
• Dryer overview screen (ES_6): shows an overview of the dryers of the plant with their status.
• Dryer switch screen (ES_7): enables the user to select the active and backup dryer.
• View screen (ES_8): enables the user to view the plant information as graph or as 2 line or 4 line inputs.
3.2

Central controller (ES-MED) operation

Gaining full access to all menus
To access certain menus like the Settings, ES, Test and Commands menu, the access key needs to be given.
In the Menu screen, navigate to the icon indicated below, enter the indicated submenu and insert the code
<2801>, using the scroll buttons.
After giving in the access code, the user has full access. When no key is pressed during several minutes, full
access disappears and needs to be re-entered if required.
CAN settings
These settings are set ex factory. To verify, the following steps can be followed after entering the Settings
submenu and then selecting Network (full access needs to be obtained, see above):
24
Instruction book
2920 7099 70