BeaconMedaes dMED 7 Instruction Book page 24

Icon Status
Failed to go on load The pressure switch at the compressor outlet detects a too low pressure
Overload
Element temperature
warning
Aftercooler
temperature warning
Sensor error
Local mode
Service required
Isolated
The icons used in the Dryer overview screen (ES_6) are as follows:
Icon Status
Dryer is operational The dryer is delivering conditioned air to the system.
Dryer is in purge
saving
Dryer is in economy
saving
Dryer is in standby
Dryer fault icons:
22
Description
when it should not.
The motor draws too much current and the overload has isolated the
compressor
The compressor element outlet temperature is too high
The compressor aftercooler temperature is too high
The compressor has a sensor error.
The compressor has either been manually set to local, was forced locally
from an ES command, or was forced locally by the Emergency Forced
Local backup system.
The compressor's running hours have surpassed the predefined interval
and maintenance must be carried out.
User has isolated this compressor controller. It will not transmit faults or
alarms.
Description
The dryer is in purge saving mode, operating its solenoid valves based
on the dew point.
The dryer is in economy mode, operating its solenoid valves based on
the working status of all connected compressors.
The dryer is in standby mode, ready to be switched on.
Instruction book
2920 7099 70