Step 10 - Turning Off The Chassis And Modules; Step 11 - Connect The M8040A To The Device Under Test (Dut); Typical Test Setup Example - Keysight Technologies M8000 Series Getting Started Manual

2 Basic Setup for M8040A

Step 10 - Turning off the Chassis and Modules

Step 11 - Connect the M8040A to the Device Under Test (DUT)

Typical Test Setup Example

USB
52
Turn off the chassis and module in the following sequence:
1 Turn off the host computer. If you are using the Keysight AXIe
Embedded Controller module as the host computer, ensure that you
shut down the controller by executing the Windows shutdown process.
2 Turn off the chassis by pressing the chassis ON/STANDBY switch on
the front panel of chassis. Do not use the circuit breaker for routine
turn off. The module(s) are turned off automatically with the chassis.
This section describes how you can connect the M8040A to a DUT.
If you are connecting M8040A over USB, make sure to disable the "Sleep
NOTE
Mode" of the external PC or laptop. Failing to do so may cause you to
re-initialize the M8070A software.
Figure 17
DUT.
External Bandpass Filter
Figure 17
on page -52 is an example of a common test setup for testing a
Typical test setup example
Keysight M8040A High-Performance BERT Getting Started Guide
Loopback to ED
DUT