Connecting The Transducers - GE TransPort PT900 User Manual

2.6.2 Connecting the Transducers

To connect the transducers, see Figure 45 below and proceed as follows:
1. Connect the cables from each of the transducers to the transmitter:
a. Connect the transducer cable with the UP label on the cable connector
to the transmitter connector labeled UP .
b. Connect the transducer cable with the DN label on the cable connector
to the transmitter connector labeled DN .
2. If your transmitter is configured for two channels, connect the second
transducer pair by repeating the above step.
3. Properly configure the transmitter to work properly with your specific
transducer type. See "Programming the Transducer Parameters" on
page 67 for instructions.
Important: Be sure to insert the cable connectors straight into the transmitter
connectors to avoid damaging the connectors.
®
TransPort PT900 User's Manual
Figure 45: Transducer Connections (Bottom)
Chapter 2. Installation
35