Connecting To A Power Supply - Christie DS Series User Manual

Connecting to a power supply

1.
Put the connector of the power cord into the AC (AC
inlet) of the product.
2.
Firmly plug the power cord's plug into the outlet. In a
couple of seconds after the power supply connection,
the POWER indicator lights up in steady orange. When the
DIRECT POWER ON function activated, the connection of
the power supply make the projector turn on.
When the AUTO POWER ON function is activated and
the projector is receiving an input signal, it is turned on by
connecting to the power supply.
3.
Use the supplied cable tie (for power cord) to fasten the
power cord.
Cable tie for power cord
WARNING
unit is attached to it.
►Use extra caution when connecting the power cord, as incorrect or faulty
connections may result in fi re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fi re, electric shock
or other accidents.
• Do not press the main body of projector on the power cord.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE
• This projector is also designed for IT power systems with a phase-
to-phase voltage of 220 to 240 V.
LWU900-DS/LHD878-DS/LWU755-DS
User's Manual - Operating Guide
►Do not connect the projector to a power supply while no lens
27
Setting up
indicator
POWER
AC
Power cord
020-001587-01 Rev. 1 (12-2018)
LIT MAN USR DS Series