Power On/Off; Turning On The Power; Turning Off The Power - Christie DS Series User Manual

Power on/off

Turning on the power

1.
Make sure that the power cord is fi rmly and correctly
connected to the projector and the outlet.
2.
Make sure that the POWER indicator is lighted in
steady orange (121). Then remove the lens cover.
3.
Press STANDBY/ON button on the projector
or the ON button on the remote control.
The projection light source lights up and the POWER
indicator begins blinking in green. When the power is
completely on, the indicator stops blinking and light
in a steady green (121).
To display the picture, select an input signal according to
the section Selecting an input signal (34).

Turning off the power

1.
Press the STANDBY/ON button on the projector or
the STANDBY button on the remote control.
The message "Power off ?" appears on the screen
for about fi ve seconds.
2.
Press the STANDBY/ON or STANDBY button again
while the message appears.
The light source goes off , and the POWER indicator
begins blinking in orange. The POWER indicator
stops blinking and lights in a steady orange when
the light source cooling is completed (121).
3.
Attach the lens cover, after the POWER indicator turns to steady orange.
(continued on next page)
LWU900-DS/LHD878-DS/LWU755-DS
User's Manual - Operating Guide
31
Power on/off
indicator
POWER
NETWORK INTERACTIVE
INFO
NETWORK INTERACTIVE
INFO
020-001587-01 Rev. 1 (12-2018)
LIT MAN USR DS Series