Table of Contents
Advertisement
6.
Slide the AP100-P into the mounting bracket. Slide the bracket's feet over the two feet of the
AP100-P closest to the keyhole mounts.
7.
Attach the mounting bracket to the ceiling tile, using two #6 screws.
8.
Position the small holes on the bracket over the small holes on the back of the AP100-P. Use two
screws supplied to attach the bracket to the AP100-P.
9.
For each antenna, loosen the knurled ring at the base of the antenna (see
antenna straight up, then retighten the ring.
10.
Return the ceiling tile to the ceiling, but leave the tile loose.
11.
Connect the PoE 100BaseT Ethernet cable to the AP100-P (see
Installing the Access Point
Figure
5), point the
Figure
6).
Installing the AP100
13
Advertisement
Table of Contents
