Figure 14 Ap200 Connector Panel - Meru Networks AP100 Installation Manual

Installing the Access Point
4.
Figure 14: AP200 Connector Panel
Vertical Mounting
To vertically mount an AP:
1.
24 Meru Access Point Installation Guide
If using a separate power supply, connect the power cable to the power inlet connector shown in
Figure 14.
(Reserved)
Console
Antenna 1
port
CONSOLE
ANT 1
Using the bracket holes as a template, mark the location on the wall for the two AP bracket
mounting screws. They are placed 4 ½ inches apart, center-to-center, one above the other. If you
are not using plastic wall anchors, you must center the mounting screws on a wall stud. If you do
not center the mounting screws on a wall stud, you must use plastic wall anchors.
Reset
100/1000
(push to restore
Ethernet
default settings)
ETHERNET
Power Antenna 2
inlet
3.3 VDC
ANT 2