Ap100 Status Leds; Figure 11 Access Point 100 Status Leds; Table 3 Ap100 Led Descriptions - Meru Networks AP100 Installation Manual

AP100 Status LEDs

Four status LEDs on the face of the AP100 also light, as shown in
.
Figure 11: Access Point 100 Status LEDs
The Power LED, farthest from the Meru logo, displays green when power is on.
The functions of the LEDs are described in Table 3.
Table 3: AP100 LED Descriptions
LED
LED1
LED2
LED3
LED4
When the AP is first connected to the controller and any time the access point is rebooted thereafter,
the AP initializes with and then is programmed by the controller. LED 2 gives the status of the boot
cycle. Table 4 lists typical successful boot information.
Function
Green: Presence of power
Boot status (see Table 4)
Green: Wireless transmit activity (TX)
Green: Wireless receive activity (RX)
Checking LED Activity
Figure 11.
Power
Boot status
Wireless TX
Wireless RX
Installing the AP100 15