Meru Networks AP100 Installation Manual page 40

Table of Contents

Advertisement

Installing the Access Point
5.
6.
7.
8.
9.
10.
Caution!
plugged into the Console port.
11.
Mounting Above a Suspended Ceiling
The optional T-bar box hanger mounting kit allows the AP200 to be mounted above suspended ceiling
T-rails (see
The AP200 attaches to the mounting bracket that is attached to the T-bar box hanger.
The AP200 antennas should point straight down for this type of installation. You may need to modify
thicker tiles to support this installation.
Note:
low smoke-generating characteristics required by Section 300-22(C) of the National Electrical Code
(NEC) for installation in a building's environmental air space. You must remove the plastic enclosure
to reveal the plenum-rated AP200 metal case for installations above a suspended ceiling.
Additionally, you must use Ethernet cable that meets the requirements for operating in environmental
air space (in accordance with Section 300-22(C) of the NEC).
28
Meru Access Point Installation Guide
Place each spacer on the caddy fastener stud. The spacer legs should contact the ceiling
T-rail.
Align the mounting bracket keyholes with the caddy fastener studs and slide the AP200 to the
narrow end of the hole.
Attach a keps nut to each caddy fastener stud and hand tighten. Do not overtighten.
Align the AP200 mounting posts over the circular portion of the keyhole mounts, push the AP in
and slide the AP down until it engages with the locking detents (see
it snap in place.
For each antenna, loosen the knurled ring at the base of the antenna (see
antenna straight down, then retighten the ring.
Connect the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet connector (see
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be
Optionally connect the external power supply cable to the AP power inlet (see
the power source.
Figure
19). The installation attaches the T-bar box hanger to the ceiling rails using clips.
The AP200 with the metal enclosure exposed meets the requirements for fire resistance and
Figure
17). You should hear
Figure
13), point the
Figure
14).
Figure
14) and to

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ap200Ap100-p

Table of Contents