Configuring Class Setup - Nortel BSR222 Configuration

Table 79 Bandwidth Manager: Summary
Label
Speed (kbps)
Apply
Reset

Configuring class setup

The class setup screen displays the configured bandwidth classes by individual
interface. Select an interface and click the buttons to perform the actions
described next. Click + to expand the class tree or click - to collapse the class tree.
Each interface has a permanent root class. The bandwidth budget of the root class
is equal to the speed you configured on the interface (see
on page 300
the root class.
To add or delete child classes on an interface, click BW MGMT, then the Class
Setup tab. The screen appears as shown in
Description
Enter the amount of bandwidth for this interface that you want to allocate
using bandwidth management.
This appears as the bandwidth budget of the interface's root class (see
"Configuring class setup" on page
this speed to match what the device connected to the port can handle.
For example, set the WAN interface speed to 1 000 kb/s (or less) if the
broadband device connected to the WAN port has an upstream speed of
1 000 kb/s.
Click Apply to save your changes to the Business Secure Router.
Click Reset to begin configuring this screen afresh.
to configure the speed of the interface). Configure subclass layers for
Nortel Business Secure Router 222 Configuration — Basics
Chapter 15 Bandwidth management 301
301). Nortel recommends that you set
"Configuring summary"
Figure 100.