Configuring Source And Destination Addresses; Figure 55 Adding Or Editing Source And Destination Addresses; Table 40 Adding Or Editing Source And Destination Addresses - Nortel BSR222 Configuration

Configuring source and destination addresses

To add a new source or destination address, click SrcAdd or DestAdd from the
previous screen. To edit an existing source or destination address, select it from
the box and click SrcEdit or DestEdit from the previous screen. Either action
displays the screen shown in

Figure 55 Adding or editing source and destination addresses

Table 40 describes the fields in

Table 40 Adding or editing source and destination addresses

Label
Address Type
Start IP Address
End IP Address
Subnet Mask
Apply
Cancel
Figure 55.
Figure 55.
Description
Select an option from the drop-down list that includes: Single
Address, Range Address, Subnet Address and Any Address.
Enter the single IP address or the starting IP address in a range here.
Use a numerical IP address in dotted decimal notation (for example,
192.168.1.10).
Enter the ending IP address in a range here. Use a numerical IP
address in dotted decimal notation (for example, 192.168.1.10).
Enter the subnet mask here, if applicable.
Click Apply to save your changes to the Business Secure Router and
exit this screen.
Click Cancel to exit this screen without saving.
Nortel Business Secure Router 222 Configuration — Basics
Chapter 11 Firewall screens 183