Configuring Wan Mac; Figure 28 Mac Setup - Nortel BSR222 Configuration

Business secure router

Hide thumbs Also See for BSR222:

Table of Contents

118 Chapter 7 WAN screens

Table 22 WAN: IP

Allow between

Allow Trigger Dial

Configuring WAN MAC

To change the WAN MAC settings of your Business Secure Router, click WAN,

then the WAN MAC tab. The screen appears as shown in

Select this check box to forward NetBIOS packets from the LAN to

the WAN and from the WAN to the LAN. If your firewall is enabled

with the default policy set to block WAN to LAN traffic, you must

also enable the default WAN to LAN firewall rule that forwards

NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the

LAN to the WAN and from the WAN to the LAN.

This field does the same as the Allow between LAN and WAN

field in the LAN IP screen. Enabling one automatically enables the

Select this option to allow NetBIOS packets to initiate calls.

Click Apply to save your changes to the Business Secure Router.

Click Reset to begin configuring this screen afresh.