Precaution About Pickup Roller Unit Installation; Pickup Roller/Separation Roller; Removing The; Removing The Feeder Cover - Canon DADF-P1 Service Manual

Chapter 3
[1] [2]

3.4.1.4 Precaution about Pickup Roller Unit Installation

- Install the pickup roller unit with the stopper arm [1] at the front as shown
below.
- Install the pickup roller unit with the stopper [2] at the rear as shown below.

3.4.2 Pickup Roller/Separation Roller

3.4.2.1 Removing the Front Cover
1) Open the feeder cover [1], and then remove the screw [2].
[2]
2) Remove the two screws [3], and then detach the front cover [4].
3-6
[3] [2] [1]
F-3-31
[2]
[1]
F-3-32
[1]
F-3-33
0010-3979

3.4.2.2 Removing the Feeder Cover

1) Remove the screw [1] and positioning pin [2], and then detach the feeder
cover [3].
[3]
[1]

3.4.2.3 Removing the Pickup Roller Unit

1) Release the two hooks [1], and then detach the inner cover [2] of the feeder
cover.
0010-6356
2) Remove the two resin rings [1] and the two bearings [2], and then remove
the pickup roller unit [3].
[1]
3.4.2.4 Removing the Pickup Roller and Separation
Roller
1) Remove the screw [1], and then remove the drive gear [2].
[3]
F-3-34
[2]
F-3-35
[1] [2] [1]
F-3-36
[2] [3] [2]
F-3-37
[4]
0010-6357
0010-6358
[1]
0010-3988