Chapter 3
[3]
[2]
[1]
3.3.3.3 Removing the Rear Cover
1) Open the feeder cover.
2) Move to the back of the machine, remove the two screws [1], and then
detach the rear cover [2].
Remove the rear cover with the two claws [3] released.
3.3.3.4 Removing the ADF Driver PCB
1) Disconnect all connectors from the ADF driver PCB. (10 connectors)
2) Remove the two screws [1], and then remove the ADF driver PCB [2].
[2]
3.3.3.5 Removing the Pickup Motor
1) Disconnect the connector [1], and then remove the tension spring [2].
2) Remove the two screws [3], and then remove the pickup motor [4]
together with the adjusting plate.
3-4
F-3-18
[1]
[2]
[3]
F-3-19
[1]
F-3-20
[3]
0010-6192
3.3.3.6 Removing the Feed Motor
1) Disconnect the connector [1], and then remove the tension spring [2].
2) Remove the two screws [3], and then remove the feed motor [4] together
with the adjusting plate.
0011-3230
3.3.3.7 Removing the Timing Belt
1) Remove the screw [1], and then disconnect the ground cable [2].
0010-6196
2) Disconnect the two sensor connectors [1].
3) Remove the harness from the harness guide [2].
4) Remove the screw [3], and remove the harness guide [2].
5) Remove the two screws [4], and then remove the metal plate [5].
6) Remove the four screws [6], and then remove the left hinge [7].
[1]
[3]
[4]
[2]
F-3-21
[4]
[1]
[2]
[3]
F-3-22
[1]
[2]
F-3-23
0010-6197
0010-3971