Pvm, Control Lever Positions; Surface Treatment - Danfoss PVG 32 Technical Information

Technical Information
PVG 32 Proportional Valve Group
Dimensions and ports description

PVM, control lever positions

Surface treatment

46 | © Danfoss | November 2017
Base with an angle of 37.5°
V310018.A
No control lever position
Control lever range
Proportional control lever range
Control lever range – float position
The angle of the handle is determined by which side of the handle that is mount towards the base.
•
If a 22.5° angle is needed the "dot" on the handle is not visible
•
If 37.5° is needed the dot should be visible
The PVG valve has as standard, an untreated surface. In certain applications, depend on different factors,
such as: salty environment, large temperature changes, high humidity, rust can develope on the surface.
This will not affect the performance of the PVG valve group. To prevent/reduce rust development,
Danfoss recommend the PVG valve group to be painted. Rust on the surface is not seen as a valid
complaint issue, neither on painted or unpainted PVG valve groups.
Base with an angle of 22.5°
V310014.A
2 x 6
±19.5°
±13.4°
22.3°
BC00000038en-US0803