Opening The Front Door Of Dx200; Checking The Switch Setting Of Jancd-Yew01-E Board; Installing Jancd-Yew01-E Board To Dx200 - YASKAWA JANCD-YEW01-E Instructions Manual

167646-1CD
Interface Board for Welding
Power Supply
4.1
4.2
4.3
4 Board Installation

4.1 Opening the Front Door of DX200

Opening the Front Door of DX200
Install the JANCD-YEW01-E board according to the following procedure:
1. By using a coin or a flathead screwdriver, rotate the door locks on the
front of the DX200 (two places) 90 degrees clockwise.
Clockwise
90
2. Rotate the main power supply switch to the "OFF" position and open
the door gently.

Checking the Switch Setting of JANCD-YEW01-E Board

1. Check to be sure that the settings of the switches on the
JANCD-YEW01-E board are correct.
2. For the switch setting, refer to chapter 3.

Installing JANCD-YEW01-E Board to DX200

1. Check to be sure that the main power supply is turned OFF.
2. Securely fix the JANCD-YEW01-E board to the DX200 by tightening
the board fixing screws firmly.
4-3
Door lock
Flathead screwdriver
HW1481264
19 of 40