Step 2: Start Cim Server On The Server; Step 3: Configure Openpegasus On The Server - Broadcom NetXtreme BCM57 Series User Manual

NetXtreme User Guide
Note: You can add these exports at the end of the .bash_profile. This file is located in the /root
directory.
• The environment variables will be set when a user logs in using PuTTY.
• On the Linux system itself, for each terminal where the environment variables are not set, run the
following command:
source /root/.bash_profile
• When you logout and login, the environment variables will be set.
Build and install OpenPegasus
From $PEGASUS_ROOT (the location of the Pegasus source root directory), run the following:
make clean
make
make repository
Note: Whenever OpenPegasus is built from source, all configurations are reset to the default values.
If you are rebuilding OpenPegasus, you must redo the configuration as mentioned in
OpenPegasus on the

Step 2: Start CIM Server on the Server

Use the command to start CIM server. To stop CIM server, use the command
cimserver
To check whether OpenPegasus has been installed properly, enter the following command:
cimcli ei -n root/PG_Interop PG_ProviderModule
Note: For OpenPegasus compiled from source, PEGASUS_HOME must be defined when you start
CIM server. Otherwise, CIM server will not load the repository properly. Consider setting
PEGASUS_HOME in the ".bash_profile" file.

Step 3: Configure OpenPegasus on the Server

Use the command to configure OpenPegasus, as shown in the following table:
cimconfig
Command
cimconfig -l
cimconfig -l -c
cimconfig -g <property name>
cimconfig -s <property name>=<value> -p
cimconfig --help
CIM server must be started before running
effect.
Broadcom ®
April 2017 • 2CS57XX-CDUM514-R
Server.
Description
List all valid property names.
List all valid property names and its value
Query a particular property.
Set a particular property.
Find out more about the command.
, and must be restarted for configuration changes to take
cimconfig
Linux Driver and Management Application Installation
Step 3: Configure
.
cimserver -s
Page 41