Broadcom NetXtreme BCM57 Series User Manual page 150

NetXtreme User Guide
A few minutes after the Windows Server 2008 R2 DVD installation process starts, a system reboot will follow.
After the reboot, the Windows Server 2008 R2 installation routine should resume and complete the
installation.
13. Following another system restart, check and verify that the remote system is able to boot to the desktop.
14. After Windows Server 2008 R2 is booted up, load the driver and run Bindview.exe.
a. Select All Services.
b. Under WFP Lightweight Filter you should see Binding paths for the AUT. Right-click and disable them.
When done, close out of the application.
15. Verify that the OS and system are functional and can pass traffic by pinging a remote system's IP, etc.
Windows Server 2012 iSCSI Boot Setup
Windows Server 2012 supports iSCSI booting and installation. Broadcom requires the use of a "slipstream" DVD
with the latest Broadcom drivers injected. See the Microsoft knowledge base topic KB974072 at
support.microsoft.com.
The following procedure prepares the image for installation and booting:
1. Remove any local hard drives on the system to be booted (the "remote system").
2. Load the latest Broadcom MBA and iSCSI boot images into the NVRAM of the adapter.
3. Configure the BIOS on the remote system to have the Broadcom MBA as the first bootable device and the
DVDROM as the second device.
4. Configure the iSCSI target to allow a connection from the remote device. Ensure that the target has sufficient
disk space to hold the new O/S installation.
5. Boot up the remote system. When the Preboot Execution Environment (PXE) banner displays, press Ctrl+S
to enter the PXE menu.
6. At the PXE menu, set Boot Protocol to iSCSI.
7. Enter the iSCSI target parameters.
8. In General Parameters, set the Boot to Target parameter to One-Time Disabled.
9. Save the settings and reboot the system.
The remote system should connect to the iSCSI target and then boot from the DVDROM device.
10. Boot from DVD and begin installation.
11. Answer all the installation questions appropriately (specify the Operating System you want to install, accept
the license terms, etc.).
When the Where do you want to install Windows? window appears, the target drive should be visible.
This is a drive connected via the iSCSI boot protocol, located in the remote iSCSI target.
12. Select Next to proceed with Windows 2012 installation.
A few minutes after the Windows 2012 DVD installation process starts, a system reboot will occur. After the
reboot, the Windows 2012 installation routine should resume and complete the installation.
13. Following another system restart, check and verify that the remote system is able to boot to the desktop.
Broadcom ®
April 2017 • 2CS57XX-CDUM514-R
iSCSI Protocol and Broadcom Boot Agent Software
Page 150