Table of Contents
Advertisement
4-8
Change The Current Archive
Set Preferences
Archive/Synchronize
2660021169012 Rev. A 2017-12
Set Preferences
1. From the Toolbar, select Records > Archive Management. The Archive Registration
dialog box appears (see
Figure
2. Select the archive of interest.
3. Check Mark as Current.
4. Close.
CIRRUS HD-OCT gives you a way to modify the default archive behavior for both Native
and DICOM Archive modes. Select Records > Preferences to access the Preferences dialog
at the Archive/Synchronize tab.
cáÖìêÉ=QJNM==mêÉÑÉêÉåÅÉë=[=^êÅÜáîÉLpóåÅÜêçåáòÉ
Figure 4-10
displays the default settings for Archive/Synchronize. It is possible to
select one, neither or both Start up and Shutdown. When finished selecting your
preferences, click OK to save your changes and exit, or click Cancel to exit without saving.
The options are described below.
Archive Alerts
By default, the system alerts you to the presence of unarchived exams upon shutdown and
asks if you want to archive them. Should you choose neither archive checkbox, the system
will not prompt you to archive at all. However, when the hard disk status turns yellow, you
may have to archive exams in order to clear enough archived exams to return the status to
green. At that time, archiving may take several hours. You must archive if the hard disk
status turns red and you cannot clear enough space to enable scanning and analysis. You
can archive manually at any time by selecting Records > Archive Now.
4-7).
CIRRUS HD-OCT User Manual
Advertisement
Table of Contents
Troubleshooting
