System Memory Configuration; Install Memory; Upgrade Memory - Shuttle FB95 User Manual

3.3 System Memory Configuration

The FB95 mainboard has two 240-pin DIMM slots that allow you to install
from 128MB up to GB of system memory. Each 240-pin DIMM (Dual In-line
Memory Module) Slot can accommodate 128MB, 256MB, 512MB, and
1GB.

Install Memory:

Install memory in any or all of the banks. The combination shown as follows.
D e n s ity
D e v i c e
W idth
S i n g l e S i d e
D o u b le
S i d e
Note: 1. Maximum installed memory is 2GB.
2. Double-side X16 DDRII DRAM chips are not supported.
3. Registered DIMM are not supported.
4. Only unbuffered without ECC DIMM are supported.
N o t e : You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically.
You can check the total system memory value in the BIOS Standard
CMOS Setup menu.

Upgrade Memory:

You can easily upgrade the system memory by inserting additional DDRII DRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
T O T A L 2 D I M M i n S i n g l e o r D u a l C h a n n e l M o d e
u p t o 4 G B a n d 2 G B p e r DIM M
1 2 8 M b it 2 5 6 M b it
X8 X16 X8
128 128 256
MB MB MB
256 256 512
MB MB MB
- 37 -
5 1 2 M b it
X16 X8 X16
256 512
512MB
MB MB
512 1024
N/A
MB MB
1 0 2 4 M b it
X8 X16
1024 1024
MB MB
2048
N/A
MB