Shuttle FB95 User Manual page 68

Suspend Mode
When this item enabled and after the set up time of system inactivity, all
devices except the CPU will be shut off.
Ø The choice: Disabled, 1Min, 2Min, 4Min, 8Min, 12Min, 20Min,
30Min, 40Min, or 1Hour.
HDD Power Down
When this item enabled and after the set up time of system inactivity, the
hard disk drive will be powered down while all other devices remain
active.
Ø The choice: Disabled or 1 Min~15 Min.
Soft-Off by PWR-BTTN
Under ACPI you can create a software power down. In a software power
down, the system can be resumed by Wake UP Alarms. This item lets you
install a software power down that is controlled by the power button on
your system. If the item is set to Instant-Off, then the power button causes
a software power down. If the item is set to Delay4 Sec. then you have to
hold the power button down for 4 seconds to cause a software power
down.
Ø The choice: Instant-Off or Delay 4 Sec.
Power On by Ring
This item determine the system will resume by activating of modem ring.
Ø The choice: Enabled or Disabled.
USB KB/MS Wake-up From S3
If you are using a USB KB/MS, and the ACPI suspend type is set to S3, or
S1&S3 you can enable this item to allow a KB/MS to wake up the system
from power saving mode.
Ø The choice: Enabled or Disabled.
Resume by Alarm
When this item enabled, your can set the date (day of the month) and
time to turn on your system.
Ø The choice: Disabled or Enabled.
Date(of Month) Alarm
This item selects the alarm Date (day of the month).
Ø Key in a DEC number: Min=0, Max=31.
Time(hh : mm : ss) Alarm
- 64 -