Shuttle FB95 User Manual page 56

TM2 Bus VID
Represents the voltageof the throttled performance statethat will be initi-
ated when the on diesensor gose from not hot to hot.
Ø The Choice: 0.8375V ~1.6000V.
Limit CPUID MaxVal
Set Limit CPUID MaxVal to 3,Should Be "Disabled" for WinXp.
Ø The Choice: Disabled or Enabled.
NX BIOS Control
This item allows you to enable/disable the NX BIOS Control.
Ø The choice: Enabled or Disabled.
Hard Disk Boot Priority
This item allows you to select Hard Disk Book Device Priority.
Bios Write Protect
This item allows you to enable or disable the Bios Write Protect.
If you want to flash BIOS, you must set it [Disabled].
Ø The choice: Enabled or Disabled.
Virus Warning
Allows you to choose the VIRUS Warning feature for IDE Hard Disk boot
sector protection. If this function is enables and someone attempts to write
data into this area, BIOS will show a warning message on screen, and an
alarm beep.
Enabled Activates automatically when the system boots up,
causing a warning message to appear when anything
attempts to access the boot sector or hard disk
partition table.
Disabled No warning message will appear when anything
attempts to access the boot sector or hard disk
partition table.
Ø The choice: Enabled or Disabled.
CPU L1&L2&L3 Cache
All processors that can be installed in this mainboard use internal level1(L1)
, external 2(L2) cache memory and (L3) to imporve performance.
Leave this item at the default value for better performance.
Ø The choice: Enabled or Disabled.
Note: CPU support, L3 item appear.
- 52 -