Usb Port - Hirschmann OWL LTE User Manual

Router Design
PoE PD

The router supports the PoE+ standard for PoE PD. You can supply
power to the router from the Ethernet ports "ETH0" or "ETH1". See the
PoE parameters located in
Requirements" on page
the "PoE" LED on the front panel of the router illuminates green indicating
that the router is using PoE power. When you use PoE to supply power to
the router, you can connect the router to a 15 V DC and higher power
source to the "Power" connector. If the power source provides less than
15 V DC, then the router uses the PoE power from the Ethernet ports.
3.7.9

USB Port

Panel socket USB
Pin Signal Mark
1 +5 V
2 USB data -
3 USB data +
4 GND
Table 8: USB connector pin-outs
Figure 18: USB connector
34
"PoE PD Technical Parameters – PSE
52. When voltage is present on an Ethernet port,
Description
Positive pole of 5 V DC supply voltage, 0.5 A
USB data signal – negative pole
USB data signal – positive pole
GND Negative pole of DC supply voltage
3.7 Description of the Front Panel
Direction
Input/Output
Input/Output
UM Installation OWL_LTE
Release 1.0 09/2015