Port Status - Hirschmann MICE MS20-0800 Series User Manual

1.2.3

Port status

These LED's display port-related information. You set the content of the
information with the button on the basic module
status").
1 to 4 – data, link status (green/yellow LED)
Not glowing
Glowing green
Flashing green (1× a period)
Flashing green (3× a period)
Flashing yellow
1 to 4 – FDX (green/yellow LED)
Not glowing
Glowing green
1 to 4 – 1000 (green/yellow LED)
Not glowing
Glowing green
Glowing yellow
1 to 4 – AUTONEG (green/yellow LED)
Glowing green
1 to 4 – RING PORT (green/yellow LED)
Glowing green
1 to 4 – STAND-BY (green/yellow LED)
Glowing green
Glowing yellow
Flashing green/yellow
TP/FO – twisted pair / fiber optic (green/yellow LED)
Glowing green
Glowing yellow
PoE status (green/yellow LED)
Not glowing
Glowing yellow
Glowing green
1 to 4 – LED TEST (green/yellow LED)
Not glowing
Flashing green/yellow
MS20/MS30 MS20/MS30
Release 10 07/2012
For MM20-A8A89999SAHH (AUI): No valid connection. No
DTE voltage at the port.
For MM20-A8A89999SAHH (AUI): Valid connection. DTE
voltage present at the port.
Port is switched to stand-by (Port 1).
Port is switched off.
Data reception.
Half-duplex is active.
Full-duplex is active.
10 Mbit/s is active.
100 Mbit/s is active.
1000 Mbit/s is active.
Autonegotiation is active.
This port is assigned to the HIPER-Ring.
Connection port for the data line.
Connection port for the control line.
No stand-by partner available.
The port LEDs of the media modules display the twisted pair
ports.
The port LEDs of the media modules display the F/O ports.
No PoE port or PoE disabled; PoE status "fault".
PoE port searching for terminal device (PD); PoE status
"searching".
PoE port supplying terminal device (PD); PoE status
"Delivering Power".
LED defective.
LED test is active.
(see on page 31 "Display
33