Display Status; Port Status - Hirschmann MICE MS20-1600 Series User Manual

1.4.2

Display status

Every media module has one LED per port. The meaning of this port status
LED depends on the setting on the basic module. You define the display
meaning with the "SELECT" button on the basic module.
 Press the button for approx. 2 seconds to switch the meaning of the
display. If the button is not pressed for approx. 20 seconds, the the display
status changes back to "L/D".
L/D – data, link status (green LED)
Glowing green
FDX – full duplex (green LED)
Glowing green
1000 – 10/100/1000 Mbit/s (green LED)
Glowing green
AN – autonegotiation (green LED)
Glowing green
RING – ring port (green LED)
Glowing green
STBY – stand-by (green LED)
Glowing green
TEST – LED test (green LED)
Glowing green
TP – twisted pair / fiber optic (green LED)
Glowing green
All display status LEDs (green LEDs)
Flashing in sequence
2 – PoE status (green/yellow LED)
Glowing green
Not glowing
3 (green LED)
1.4.3

Port status

These LED's display port-related information. You set the content of the
information with the button on the basic module
status").
Installation MS20/MS30
Release 11 07/2013
The port LEDs of the media modules display the connection
status.
The port LEDs of the media modules display the half-duplex or
full duplex connection status.
The port LEDs of the media modules display the set
transmission speed.
The port LEDs of the media modules display the port
configuration type.
The port LEDs of the media modules display HIPER-Ring
assignment.
The port LEDs of the media modules display the assignment to
a redundant coupling of network segments.
The status, display status and port status LED test is active.
The P1/P2 LEDs glow green.
The "RM" LED status flashes green/yellow.
The RELAY1/RELAY2 status LEDs flash yellow/red.
The display status LEDs flash green.
The port status LEDs of the media modules flash green/yellow.
The port LEDs of the media modules display the media type.
Initialization phase after restart.
The port LEDs of the media modules display the Power over
ETHERNET status.
- No PoE port or PoE disabled.
- PoE status "fault".
Service LED
(see on page 29 "Display
29