Replacement Of The Electrical Components; On-Site Painting Make-Up Measures - Sungrow SG2500U-MV System Manual

Mv turnkey station

Table of Contents

System Manual

Proceed as follows to clean or replace the filter:

Remove the six screws used to fix the frame of the air inlet window;

Step 1

Remove the filters and clean them with warm water and detergent, and wait until it is

Step 2

completely dry; if the filter needs to be replaced, remove the old filter and place the new

one.

Reassemble the filter according to the reverse procedure shown above.

Step 3

Filter cotton can be ordered from Sungrow. Depending on the filter type and

model, user can cut out small cotton from the larger ones.

12.2.5 Replacement of the electrical components

The electrical components inside the MV Station must be replaced by the same

components from the same manufacturer and with the same model number.

The model number can be acquired from the marking of the MV Station or the

component itself. If otherwise, please contact Sungrow.

If the field work needs to replace the components with products from other

manufacturer or with different model number, a prior analysis and confirmation

by Sungrow are required.

Failure to follow this procedure may lead to physical injury or death and void all

warranty from Sungrow.

12.3

Check for the damages of the MV Station appearance:

Situation 1: smudginess on the surface caused by water and dust that can be cleaned

Situation 2: smudginess on the surface & damage to the finishing coat that cannot be

cleaned

Fig. 12-1 Clean or replace the air inlet window

12 Routine Maintenance

Table of Contents