Ms Introduction; Differences In The User Interfaces - GE MDS Mercury Series Reference Manual

05-4446A01, Rev. C

3.1 MS INTRODUCTION

The transceiver's embedded management system is accessible through
the (serial) port, the
COM1
Ethernet. Telnet, SSH, HTTP/HTTPS, and SNMP are the
Ethernet-based interfaces. Essentially, the same capabilities are avail-
able through any of these paths.
For support of SNMP software, a set of MIB files is available for down-
load from the GE MDS Web site at
SNMP commands can be found at SNMP Agent Configuration
on Page 53 of this manual.
The transceiver's Management System and its functions are divided into
seven functional groups as listed below.
• Section 3.3, BASIC OVERVIEW OF OPERATION (beginning
on Page 40)
• Section 3.4, CONFIGURING NETWORK PARAMETERS
(beginning on Page 43)
• Section 3.5, RADIO CONFIGURATION (beginning on Page
58)
• Section 3.7, SECURITY CONFIGURATION MENU (beginning
on Page 85)
• Section 3.13, PERFORMANCE OPTIMIZATION (beginning on
Page 127)
• Section 3.12, MAINTENANCE/TOOLS MENU (beginning on
Page 113)
Each of these sections has a focus that is reflected in its heading. The
section you are now reading provides information on connecting to the
Management System, how to navigate through it, how it is structured,
and how to perform top-level configuration tasks.
shows a top-level view of the Management System (MS).

3.1.1 Differences in the User Interfaces

Although there are slight differences in navigation among the user inter-
faces, the content is very similar. You will notice a few differences in
capabilities as the communications tool is driven by limitations of the
access channel. Figure 3-2
the Starting Information Screen as seen through a console terminal and
a web-browser, respectively.
Mercury Reference Manual
(Ethernet) port, and using over-the-air
LAN
www.GEmds.com
and Figure 3-3 on Page 33
. An overview of
section
Figure 3-1 on Page 32
show examples of
31