GE MDS Mercury Series Reference Manual page 54

46
Network Interface Configuration Menu—VLAN Items
Figure 3-13. VLAN Configuration Menu
• —Defines whether the radio handles Ethernet
VLAN Status
frames in "extended" 802.1Q mode or in "normal" mode in the
Ethernet port. If configured with a trunk port, the Mercury
passes all tagged traffic regardless of the VLAN ID. The Mer-
cury only uses the
configured as an Access Port.
[
enabled, disabled; disabled
•
VLAN Ethport Mode
port or as an access port. Auto mode defines the port as a trunk
port in an AP, or an access port in a Remote radio.
[
Auto, Trunk, Access; Auto
•
Management VLAN ID
to the radio itself, other than the terminal server process. This
VLAN ID is used for filtering and for tagging purposes.
[ ]
1-4094; 2
• —Defines the VLAN ID assigned to traffic directed
Data VLAN ID
to and from the Ethernet port and the terminal server process in
the radio. This VLAN ID is used for filtering and tagging pur-
poses. [
1-4094; 3
•
Default Route IF
gateway in the radio. [
•
Management VLAN Mode
frames. [
Tagged, Native; Tagged
•
Management VLAN Subnet Config
can set the IP Address Mode, Static IP Address, and Static IP
Netmask (see
•
DHCP Server Config (Mgmt)
view or set the DHCP server status and address information for
management functions (see
Mercury Reference Manual
Invisible place holder
parameter when the
Data VLAN ID
]
—Defines if the Ethernet port acts as a trunk
]
—Defines the VLAN ID for traffic directed
]
—Defines the VLAN that contains the default
MGMT, DATA; MGMT
—Applies the VLAN tag to management
].
—Presents a screen where you
Figure 3-14 on Page 47).
—Presents a screen where you can
Figure 3-15 on Page
port is
ETH
]
48).
05-4446A01, Rev. C