GE MDS Mercury Series Reference Manual page 7

The majority of GE MDS radios deployed since 1985 are still installed and performing within our
customers' wireless networks. That's because we design and manufacture our products in-house,
according to ISO 9001 which allows us to control and meet stringent global quality standards.
Our durable products and comprehensive solutions has made GE MDS the wireless leader in indus-
trial automation—including oil and gas production and transportation, water/wastewater treat-
ment, supply and transportation, electric transmission and distribution and many other utility
applications. GE MDS is also at the forefront of wireless communications for private and public
infrastructure and online transaction processing. Now is an exciting time for GE MDS and our cus-
tomers as we look forward to further demonstrating our abilities in new and emerging markets.
As your wireless needs change you can continue to expect more from GE MDS. We'll always put
the performance of your network above all. Visit us at
OPERATIONAL & SAFETY NOTICES
RF Exposure
Professional installation required. The transceiver described here emits radio frequency
energy. Although the power level is low, the concentrated energy from a directional
antenna may pose a health hazard. Do not allow people to come closer than 20 cm
(7.87 inches) to the antenna when the transmitter is operating. This calculation is
based on an 18 dBi panel antenna. Additional information on RF exposure is on the
Internet at
ERP Compliance
To maintain regulatory compliance for Effective Radiated Power (ERP) of 1-Watt per MHz, the
following table of transmit power settings must be observed for the listed bandwidths and antenna
types approved. Consult the factory for other antenna options of lower gain.
CSA/ Notice
us
This product is approved for use in Class 1, Division 2, Groups A, B, C & D Hazardous Locations. Such locations are
defined in Article 500 of the National Fire Protection Association (NFPA) publication NFPA 70 , otherwise known as
the National Electrical Code.
The transceiver has been recognized for use in these hazardous locations by the Canadian Standards Association
(CSA) which also issues the US mark of approval (CSA/
C22.2 No. 213-M1987.
05-4446A01, Rev. C
www.fcc.gov/oet/info/documents/bulletins
). The CSA Certification is in accordance with CSA STD
US
Mercury Reference Manual
www.GEmds.com for more information.
.
v