Accessories - GE MDS Mercury Series Reference Manual

05-4446A01, Rev. C
Table 1-2. Security Risk Management
Security Vulnerability
Unprotected access to configuration via
SNMPv1
Intrusion detection

1.6 ACCESSORIES

The transceiver can be used with one or more of the accessories listed in
Table 1-3. Contact the factory for ordering details.
Accessory Description
AC Power A small power supply module designed for
Adapter Kit continuous service. UL approved. Input:
120/220; Output: 13.8 Vdc @ 2.5 A
Omni- Rugged antennas well suited for use at Access
Directional Point installations. Consult with your factory
Antennas Sales Representative for details
Yagi Antenna Rugged antennas well suited for use at fixed
(Directional) Remote sites. Consult with your factory Sales
Representative for details.
GPS Receiving A variety of fixed and mobile GPS antennas
Antennas (active and passive) are available. Consult with
your factory Sales Representative for details.
TNC Male-to-N One-piece RF adaptor plug.
Female Adapter
TNC Male-to-N Short length of coaxial cable used to connect the
Female Adapter radio's TNC antenna connector to a Type N
Cable commonly used on large diameter coaxial
cables.
Ethernet RJ-45 Cable assembly used to cross-connect the
Crossover Ethernet ports of two transceivers used in a
Cable (CAT5) repeater configuration.
(Cable length ≈ 3 ft./1M)
Mercury Reference Manual
GE MDS Cyber Security Solution
•
Implement SNMPv3 secure
operation
•
Provides early warning via SNMP
through critical event reports
(unauthorized, logging attempts,
etc.)
•
Unauthorized AP MAC address
detected at Remote
•
Unauthorized Remote MAC
address detected at AP
•
Login attempt limit exceeded
(Accessed via: Telnet, HTTP, or
local)
•
Successful login/logout
(Accessed via: Telnet, HTTP, or
local)
Table 1-3. Accessories
GE MDS
Part No.
01-3682A02
--
--
--
97-1677A161
97-1677A159
(3 ft./1m)
97-1677A160
(6 ft./1.8m)
97-1870A21
17