Gps Configuration (Remote Only) - GE MDS Mercury Series Reference Manual

98
•
Maximum Receive Errors
mum allowable number of receive errors. When the number of
errors exceeds this number, a redundancy switchover occurs.
[ ]
0-1000; 500
3.9 GPS CONFIGURATION (REMOTE
ONLY)
This menu allows you to view or set important parameters for the
built-in Global Positioning System (GPS) receiver in the Mercury
Remote.
Figure 3-67. GPS Configuration Menu (Remote Only)
•
Stream GPS to Console
GPS NMEA data to the console port (
baud when Stream GPS to console is enabled.
[
enabled, disabled; disabled
•
GPS to Console Baud Rate
streaming is enabled.
•
Send GPS via UDP
data to a server via UDP. [
•
GPS UDP Server IP Address
GPS NMEA UDP packets. [
•
GPS UDP Server UDP Port
NMEA UDP packets. [
•
GPS Streaming Configuration
NMEA outputs. (See
Mercury Reference Manual
—Select this item to change the maxi-
Invisible place holder
—Used to enable/disable streaming of
COM1
]
—The serial baud rate when GPS
—Used to enable/disable sending GPS NMEA
enabled, disabled; disabled
—Specify the destination address for
any valid IP address; 0.0.0.0
—Destination UDP port for GPS
valid UDP port number; 0
—A submenu for setting GPS
Figure 3-68 on Page
). Baud rate is 4800
]
]
]
99.)
05-4446A01, Rev. C