GE MDS Mercury Series Reference Manual page 26

18
Table 1-3. Accessories (Continued)
Accessory Description
2-Pin Power Mates with power connector on transceiver.
Plug Screw terminals provided for wires, threaded
locking screws to prevent accidental disconnect.
Ethernet RJ-45 Cable assembly used to connect an Ethernet
Straight-thru device to the transceiver. Both ends of the cable
Cable (CAT5) are wired identically.
(Cable length ≈ 3 ft./1M)
EIA-232 Shielded cable terminated with a DB-25 male
Shielded Data connector on one end, and a DB-9 female on the
Cable other end. Two lengths available (see part
numbers at right).
EIA-232 Shielded cable terminated with a DB-9 male
Shielded Data connector on one end, and a DB-9 female on the
Cable other end, 6 ft./1.8m long.
Flat-Surface Brackets: 2" x 3" plates designed to be screwed
Mounting onto the bottom of the unit for surface-mounting
Brackets & the radio.
Screws
Bracket screws: 6-32/1/4" with locking
adhesive. (Industry Standard MS 51957-26)
Fuse Internal fuse, 5.0 Ampere
DIN Rail Bracket used to mount the transceiver to
Mounting standard 35 mm DIN rails commonly found in
Bracket equipment cabinets and panels.
COM1 Interface DB-25(F) to DB-9(M) shielded cable assembly
Adapter (6 ft./1.8 m) for connection of equipment or other
EIA-232 serial devices previously connected to
"legacy" units. (Consult factory for other lengths
and variations.)
Bandpass Filter Antenna system filter that helps eliminate
interference from nearby paging transmitters.
Ethernet Surge Surge suppressor for protection of Ethernet port
Suppressor against lightning.
Mercury Reference Manual
GE MDS
Part No.
73-1194A39
97-1870A20
97-3035L06
(6 ft./1.8m)
97-3035L15
(15 ft./4.6m)
97-1971A03
82-1753-A01
70-2620-A01
29-1784A04
03-4022A03
97-3035A06
20-2822A02
29-4018A01
05-4446A01, Rev. C