Saving The System Configuration; Enabling Ethernet/Ip Communication Protocol - Banner Sure Cross DX80 Instruction Manual

Hide thumbs Also See for Sure Cross DX80:

Table of Contents

1. Open a Web browser and log into the Ethernet Bridge or GatewayPro by typing the IP address in the browser

location window: http://192.168.0.1.

The Web home page for the Ethernet Bridge or GatewayPro displays.

2. Click on any tab at the top of page to log into the configuration software.

3. Enter system as the user name and admin as the password.

After making your changes and saving the file, close the browser to log out of the configuration system.

10.1.2 Saving the System Configuration

Save the system configuration by going to the

•

To write the changes to the factory default XML file (BootConfig.xml), click the Save button.

•

To save the configuration changes under a different file name, enter the new XML file name, including the .XML

extension, in the New File Name box and click the Save As button.

To define which XML configuration file loads when the device cycles power or restarts, enter the file name in the Startup

Configuration box.

Cycle power to the Ethernet Bridge or GatewayPro to complete this update. After the device powers up, the changes

should be registered.

By default the Ethernet Bridge and GatewayPro systems communicate using Modbus/TCP, but the system can also use

™

EtherNet/IP

To change the system to EtherNet/IP, log in using the following user name and password.

System > Setup > Config File page.

www.bannerengineering.com - Tel: +1.763.544.3164

Sure Cross

Radio Networks and Host Controller Systems

Table of Contents