Banner Sure Cross DX80 Instruction Manual page 40

®
Sure Cross Radio Networks and Host Controller Systems
User name: root
Password: sxi
System > Setup > Network page is a checkbox to enable EtherNet/IP. Only select this box if the
At the bottom of the
GatewayPro system is running on an EtherNet/IP network. This change cannot be enabled from a login other than the "root"
login.
After selecting the EtherNet/IP Enabled checkbox, click the Set Ports button to save any changes made to the HTTP Port,
Modbus Server Port, Telnet Port, and EtherNet/IP Enabled box. Cycle power to the Ethernet Bridge or GatewayPro to
complete this update. After the device powers up, the changes should be registered.
For some SureCross devices, the Ethernet/IP checkbox may be enabled as the factory default.
To use EtherNet/IP, the GatewayPro or DX83 Ethernet Bridge interface requires the user to enable the EtherNet/IP interface,
define the EtherNet/IP registers, and save the system configuration using the
Defining EtherNet/IP Registers to Send to the Buffer
Define the registers sent to the EtherNet/IP interface buffers.
On the System > Data > Local Registers screen, select EtherNet/IP for every register to be visible by Ethernet/IP. After
selecting the registers, click Update to save the changes on this configuration page.
For some Sure Cross devices, the EtherNet/IP checkbox may be enabled at the factory.
In the example screen shown, Node #1 Tank Alarm is mapped to EtherNet/IP buffer input 1, Node #1 Tank Level is mapped
to buffer input 2, and Node #1 Status is mapped to buffer input 3. Only local registers defined by the EIP checkbox will be
mapped to the EtherNet/IP buffer inputs.
After all selected inputs for device 1 are mapped to the EtherNet/IP buffer inputs, EIP selected inputs for the remaining
devices are mapped in the order of the device (e.g. device 1, device 2, device 3).
40 www.bannerengineering.com - Tel: +1.763.544.3164
System > Setup > Config File page.