Extended Switching Software Requirement; Release Highlights For 8.2.3; Release Highlights For 8.2.0 - 3Com Corebuilder 6000 Software Installation And Release Notes

2 C B 6000 E
ORE UILDER
Extended Switching
Software
Requirement
Release Highlights
for 8.2.3
Release Highlights
for 8.2.0
S S
XTENDED WITCHING OFTWARE
If you have an LMM+ at a revision earlier than 1.21 (for revision 1 modules)
or 2.12 (for revision 2 modules), call 3Com at 1-800-876-3266 and press
option 2. 3Com will replace your LMM+ with an LMM+ at the correct
revision, free of charge. (Contact 3Com at the same number to upgrade an
LMM to an LMM+. There is a fee for this upgrade.)
Release 8.0.0 or greater of Extended Switching Software requires a
minimum of 2 MB of memory on Ethernet/FDDI Switching Modules
(EFSMs). Memory configuration may vary. If you have an EFSM with 1 MB of
memory, you can order a memory upgrade. Contact your sales
representative.
To determine the amount of memory on the EFSM, look at the lower ejector
tab label or use the
system display
Administration Console. EFSMs with only 1 MB of memory have blank
lower ejector tabs. EFSMs with a minimum of 2 MB of memory have "2MB"
on the lower ejector tab labels.
CoreBuilder system software release 8.2.3 offers support for the following
items:
Software support for protocol-based VLANs
Support for seven RMON data groups
IP interface configuration change
Routing on FESM Modules
Additional RMON MIB support
RMON support for FDDI switched ports
For more information about this release, see
on page 9.
CoreBuilder system software release 8.2.0 supports the following items:
Fast Ethernet Switching Module (FESM)
FESM and FSM HSI Switch Engines
Ability to administer Fast Ethernet Ports
Bridge MIB support for the FESM
R 8.2.3
EVISION
command from the top level of the
"What's New at Revision 8.2.3?"