Table of Contents
Advertisement
Loading 8.2.3 software into flash memory takes approximately 10 to 15
minutes to complete, depending on your network load.
To load the new software:
1 From the top level of the Administration Console, enter:
system softwareUpdate
The system prompts you for the Host IP address, Install filename, User name,
and Password. Press Return or Enter to accept the default values, which are
shown in brackets. The Password field does not display what you enter.
2 Next to
Host IP address
as a Sun workstation or PC) from which you are installing the software.
In the example in step 5, the IP address of the host is
3 Next to
Install file pathname
For MS-DOS system syntax, you must precede the full path with a slash ( / ).
For example, if you are loading software from an MS-DOS host, enter the
following command at the
/c:\3com\lp6000R\image\lp6000R
4 Next to
User name
5 Next to
, enter your password. You must enter a value for this
Password
field, although the field does not display what you enter.
This software installation sample shows the prompts on a UNIX host:
Host IP address [192.9.200.14]: 192.9.200.96
Install file pathname [/usr/lp6000R/lp6000R]:
User name: ronnyk
Password:
Programming flash memory block 1 of 25...
Programming flash memory block 2 of 25...
Programming flash memory block 3 of 25...
.
.
.
Programming flash memory block 25 of 25...
Loading System Software on the LMM+
, enter the IP address of the host machine (such
, enter the complete path and filename.
Install file pathname
, enter your user name.
7
192.9.200.96
prompt:
Advertisement
Table of Contents
Need help?
Do you have a question about the Corebuilder 6000 and is the answer not in the manual?
Questions and answers