Table of Contents
Advertisement
26
C
B
ORE
UILDER
Known Problems
6000 E
S
XTENDED
WITCHING
The following software problems are identified at this release:
To compile lpv2.mib with a version 2 compiler, perform these steps:
1 In the IMPORTS section, add:
RowStatus
2 A few lines below, add the following RowStatus comment:
-- RowStatus
The new IMPORTS section now looks like this:
LANPLEX-SYSTEMS-MIB-1-4-1 DEFINITIONS ::= BEGIN
IMPORTS
enterprises, Counter, Gauge, IpAddress
DisplayString
OBJECT-TYPE
RowStatus
TRAP-TYPE
-- Textual conventions
-- RowStatus as defined in SNMPv2
-- Refer to rfc1443.txt for concise definition
-- This is a place holder until lp.mib is fully compliant
with SNMPv2
-- RowStatus
Do not create port groups and port group filters on the FESM or FSM.
The FESM and TMM-FE rxFrames, txFrames, rxBytes, and txBytes statistics
can report inaccurate values.
The FESM FDDI MAC rxFrames, txFrames, rxBytes, and txBytes statistics can
report inaccurate values.
CoreBuilder 6000 system software does not route FDDI multicast frames
that are larger than 1500 bytes (that is, frames that require fragmentation).
The NVRAM conversion for SNMP traps does not adjust correctly after you
install CoreBuilder software revision 8.2.3. Verify that the appropriate traps
are enabled.
S
R
8.2.3
OFTWARE
EVISION
FROM SNMPv2-TC
::==
INTEGER (1..6)
::==
INTEGER (1..6)
FROM RFC1155-SMI
FROM RFC1213-MIB
FROM RFC-1212
FROM SNMPv2-TC
FROM RFC-1215
Advertisement
Table of Contents
