6
Troubleshooting and Test Functions
Overview of the Detector's Indicators and Test Functions
Status Indicators
The detector is provided with two status indicators which indicate the
operational state (prerun, run, and error states) of the detector. The status
indicators provide a quick visual check of the operation of the detector (see
page
Error Messages
In the event of an electronic, mechanical or hydraulic failure, the detector
generates an error message in the user interface. For each message, a short
description of the failure, a list of probable causes of the problem, and a list of
suggested actions to fix the problem are provided, see
the Service
Wavelength Recalibration
Wavelength recalibration is recommended after repair of internal components
to ensure correct operation of the
properties of the excitation and emission light characteristics, see
"Wavelength Verification and Calibration" in the Service
Test Functions
A series of test functions are available for troubleshooting and operational
verification after exchanging internal components, see
Service
100
101).
Manual.
Manual.
detector
. The detector uses specific
1200 Series FLD User Manual
"Error Information" in
Manual.
"Test Functions" in the