Upgrade Program Components; Figure 7-8 Program Download Dialog - Emerson Daniel 3410 Series Operation Manual

3410 Series Gas Ultrasonic Meters Operations Manual
3-9000-777 Rev D
7.7

Upgrade program components

Use the Daniel MeterLink
in Daniel Ultrasonic meter. When the dialog is first opened, the Currently Installed Versions table
will show the currently installed program components in the meter.
The firmware to download to a meter is available as a compressed file with a.zip extension.
Daniel MeterLink unzips the file when it is opened.

Figure 7-8 Program download dialog

1.
2.
3.
Upgrade program components
Tools|Program Download
Click to display an Open Download File dialog and select the desired file and click
Open
.
Open
The filename displays in the
components to download display in the table under
be identified as if they are older, newer, or the same as what is currently installed in the
meter.
Daniel MeterLink only downloads components that are different than what is currently
installed in the meter. At least one component must be different for download before
the button is enabled.
Download
Click to initiate the download process. Daniel MeterLink collects the
Download
configuration from the meter and displays a message where it was saved. If the upgrade
requires the database to be reset, then it will be necessary to use the
dialog to write this configuration back down to the meter after the
Configuration
program download is complete
progress bar will appear showing the status of the file download. After the files have
been transferred successfully to the meter, the meter will start the upgrade process and
the status will be shown down below
dialog to upgrade the program components
edit box under
File Upgrade
Upgrade
(see Section 7.1). After the configuration is saved, a
Upgrade Progress
Section 7: Tools commands
June 2016
. The Version and Date of the
. All of the components will
Edit/Compare
.
135