Connecting A Cable To A 10Ge Port - Huawei 5288 V3 V100R003 User Manual

5288 V3 Server
User Guide
Figure 3-22 Connecting a network cable to management and service network ports
Step 6 Connect the other end of the network cable to the peer network port.
Connect the other cable connector to the peer device based on the network plan. Note the
following:
l
l
Step 7 Check that the new network cable is functioning properly.
Power on the device, and ping the peer device connected by the new network cable. If the
peer device cannot be pinged, check whether the network cable is damaged or the connectors
are not secured.
Step 8 Bind the new network cable with other cables.
Bind the new network cable in the same way as the existing network cables. You can also
remove all cable ties and bind all of the network cables again if necessary.
----End

3.5.3 Connecting a Cable to a 10GE Port

Connect an optical cable or SFP+ cable to a 10GE port. Before the connection, determine the
cable type and ensure that the cable to be connected is of the same model as the one to be
replaced or is compatible with the server.
The following tools are available:
l
l
Procedure
Step 1 Check the new network model.
Step 2 Number the new cable.
l
Issue 26 (2018-11-19)
Connect the new network cable to the same port as the removed one.
Install the network cable in the network port securely.
Phillips screwdriver: used to tighten screws
ESD wrist strap or ESD gloves: used to prevent ESD damage
The new cable must have the same number as the old one.
Copyright © Huawei Technologies Co., Ltd.
3 Installing and Removing the 5288 V3
72