Connecting A Network Cable - Huawei 5288 V3 V100R003 User Manual

5288 V3 Server
User Guide
Step 2 Connect the connectors on the other end of the PS/2 cable to the keyboard and mouse.
Step 3 Connect the DB15 connector on one end of a VGA cable to the VGA port on the rear panel of
the server. Tighten the screws on both sides of the connector to secure the cable.
Step 4 Connect the other end of the VGA cable to the VGA port on the monitor. Tighten the two
screws on the connector to secure the cable.
Figure 3-21 Connecting a USB-to-PS/2 cable and a VGA cable
----End

3.5.2 Connecting a Network Cable

Connect a network cable in the following scenarios:
l
l
l
l
Conditions:
l
l
l
The following tools are available:
l
Issue 26 (2018-11-19)
The network needs to be set up over a gigabit Ethernet (GE).
You want to log in to the iMana/iBMC of the server using the management network port
for device management.
One or more network cables do not work.
A network cable needs to be replaced if the existing network cable does not meet length
requirements after a device is replaced or moved.
Use a network cable tester to check that the new network cable works properly.
Check that the new network cable is of the same model as or compatible with the
network cable to be replaced. Determine whether they are straight-through or crossover
cables.
Before installing a network cable to a network port, check that the network cable
connector is intact and the pins have no sundries or deformation.
Phillips screwdriver: used to tighten screws
Copyright © Huawei Technologies Co., Ltd.
3 Installing and Removing the 5288 V3
70