Huawei 5288 V3 V100R003 User Manual page 28

5288 V3 Server
User Guide
Rear Panel
Table 2-6
Table 2-6 Indicators on the rear panel
Indicator
Management
network port
UID indicator
PSU indicator
Hard disk activity indicator
Hard disk fault indicator
Table 2-7
Issue 26 (2018-11-19)
describes the indicators on the 5288 V3 rear panel.
Data
transmission
status indicator
Connection
status indicator
describes the NVMe PCIe SSD indicators on the 5288 V3 rear panel.
Copyright © Huawei Technologies Co., Ltd.
State
l Off: No data is being transmitted.
l Blinking yellow: Data is being transmitted.
l Off: The network port is not connected.
l Steady green: The network port is properly
connected.
l Off: The server is not located.
l Steady blue: The server is located.
750 W AC Platinum PSU
l Off: There is no AC power input; the input
overvoltage or undervoltage occurs and the
PSU is not detected; the PSU is abnormal.
l Steady green: Both the active output and the
standby output are normal.
l Off: The hard disk is not detected or is faulty.
l Blinking green: Data is being read from or
written to the hard disk, or synchronized
between hard disks.
l Steady green: The hard disk is inactive.
l Off: The hard disk is working properly.
l Blinking yellow: The hard disk is located, or
rebuilding RAID.
l Steady yellow: The hard disk is faulty, or hard
disk members of the RAID array the hard disk
is in are abnormal.
NOTE
If the fault indicator is steady yellow, run related
commands to check the RAID status to determine
whether the RAID array status is abnormal or whether
the hard disk is faulty. For details about command
description, see HUAWEI V2&V3 Server RAID
Controller Card User Guide.
2 Product Overview
18