Problem Solving Guide - Westinghouse 907 series Care & Use Manual

HELP & PROBLEM SOLVING GUIDE

Problem Solving guide.

FAULT
Not operating
Not working
Won't start
Door Issues
Door hitting left or right at top
Door hard to close
Door not closing
Door opens easily
Operational problems
Dispenser not opening
10 Displayed (915 & 925)
- repeating single beep (907)
20 Displayed (915 & 925)
- repeating double beep (907)
Noisy in wash
Not advancing
Not heating
Water on floor- flooding
Won't wash
Fill
Filling & emptying
Noisy when filling
Slow filling
Water does not enter unit
Not enough water
Not filling- No water
Water Hammer
POSSIBLE CAUSE
No power
Power supply not connected
Door not properly closed
Dishwasher is in Pause mode.
"P" flashes on digital display window
All lights flashing (model 907)
Unit is not level at rear
Top basket not fully pushed in
Bottom basket running off the track
Loose spoon or pot handle sticking
out
Not filling
Not draining
Spray arm hitting an object
Door not properly closed
Unit is in pause mode
Rinse program is selected
Poor installation. Hose connections /
hoses
Wrong program is selected.
Drain hose is too low or not hung
correctly under bench
Pressure reduction valve is required Refer to installation instructions.
Poor water supply pressure/Tap not
on properly
Inlet blockage
Tap turned off
Pressure reduction valve is required Refer to installation instructions.
SOLUTION
Check power turned on / Power button is on.
Check plug is in & switched on
Check power point by using another appliance.
Check fuse box & circuit breaker
Check door closed. Push door until latch clicks.
Press START button to un-pause the machine.
Adjust rear-levelling legs as per installation
instructions.
Make sure top and bottom baskets are in
position.
Make sure nothing obstructs the dispenser door
from opening.
Check water supply & tap
Check inlet hose filter
Check drain hose for kinks.
Check sink trap spigot for blockage.
Check filters and clean if dirty.
Make sure spray arm is free to turn.
Push door until latch clicks.
Press START button to un-pause the machine.
Choose any other program
Check connections and hoses.
Refer Program /Option selection Guide
Check installation instructions
Check tap is on.
Check for kinks & sharp bends in inlet hose.
Check inlet hose filter washer at tap.
Check tap is on.
15