Table of Contents
Advertisement
1
1.
Pull off edge connector of corresponding print head, do NOT pull the wires.
2. Open the cover in front.
3. Pull out print-head
4. Reverse the assembly of the hot-end into the extruder assembly. Do not forget to close the lid.
IMPORTANT: Ensure the hot-end wires make the bend as shown in picture above
5. Please do the following two extruder calibrations, if you wish to properly print with dual head.
Z-height calibration
-
XY calibration
-
TIP: Clean hot-end exterior from filament before starting a print, to prevent blobs of plastic on your printed
object.
Quick Start Guide FELIX Pro 3 Touch
25 January 2019
3
2
25
Page
Advertisement
Table of Contents
