How To Remove The Snow Hood - Craftsman C950-52850-0 Owner's Manual

HOW TO REMOVE THE SNOW HOOD

To access the spark plug, the snow hood must be removed
as follows:
1. Remove the choke control knob (see Figure 24).
2. Remove the ON/OFF key.
3. Remove the four mounting screws.
4. Slowly remove the snow hood (see Figure 25). Make
sure that the primer button hose and the ignition wire are
not disconnected.
5. To install the snow hood, first make sure that the primer
button hose and the ignition wire are connected.
6. Mount the snow hood to the engine and secure with the
four mounting screws (see Figure 26).
7. Align the tab on the choke control knob with the slot in the
snow hood (see Figure 27).
8. Connect the choke control knob with the choke shaft.
Make sure the choke control knob is properly installed.
If the choke control knob is not installed correctly, the
choke will not operate.
Choke Control Knob
Screws
Snow Hood
ADJUSTMENT/REPAIR
ON/OFF
Key
Screws
Figure 24
Snow Hood
Snow Hood
Tab
Slot
Carburetor
28
Figure 25
Figure 26
Choke Control
Knob
Figure 27