How To Remove The Snow Hood - Craftsman 536.888110 Operation Manual

HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow
hood must be removed as follows:
1. Remove the choke control knob
(see Figure 27).
2. Remove the safety key.
3. Remove the mounting screws
(see Figure 28).
4. Slowly remove the snow hood.
Make sure that the primer button
hose and the ignition wire are not
disconnected.
5. The spark plug can now be ac-
cessed.
6. To install the snow hood, first make
sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood to the engine
and secure with the mounting
screws (see Figure 28).
8. Connect the choke control knob
with the choke shaft on the carbure-
tor (see Figure 29 and Figure 30).
Make sure the choke control knob is
properly installed. If the choke con-
trol knob is not installed correctly,
the choke will not operate.
9. Install the safety key.
Choke
Figure 27
Snow Hood
Spark k
Plug
Choke
Control Knob
Mounting Screws
Hose
gure 28
Choke Shaft
Figure 29
Key
Carburetor
Figure 30
F-041050L 24