How To Remove The Snow Hood - Craftsman C950-52843-0 Owner's Manual

HOW TO REMOVE THE SNOW HOOD

To access the spark plug, the snow hood must be removed
as follows:
1. Remove the choke control knob (see Figure 31).
2. Remove the safety key.
3. Remove the mounting screws (see Figure 32).
4. Slowly remove the snow hood. Make sure that the prim-
er button hose and the ignition wire are not discon-
nected.
5. The spark plug can now be accessed.
6. To install the snow hood, first make sure that the primer
button hose and the ignition wire are connected.
7. Mount the snow hood to the engine and secure with the
mounting screws (see Figure 32).
8. Connect the choke control knob with the choke shaft on
the carburetor (see Figure 33 and 34). Make sure
the choke control knob is properly installed. If the choke
control knob is not installed correctly, the choke will not
operate.
9. Install the safety key.
Choke Control
Knob
ADJUSTMENT/REPAIR
Safety Key
Figure 31
28
Mounting Screws
Snow Hood
Spark
Plug
Primer Button
Choke Control Knob
Choke Shaft
Safety Key
Carburetor
Ignition
Wire
Hose
Figure 32
Figure 33
Figure 34