Snow Chute Assembly - Craftsman C950-52850-0 Owner's Manual

SNOW CHUTE ASSEMBLY

Assemble Chute Deflector
NOTE: The chute ring assembly (A) comes installed
on the unit from the factory (see Figure 7).
NOTE: Make sure the notch in the chute ring aligns
with the arrow on the outer ring.
1. Install chute deflector (B, Figure 7) using four
four screws (C) and nuts (D) in holes as shown.
The chute deflector must point forward for proper
installation.
2. Tighten screws snugly but be careful not to
over-tighten.
Assemble Remote Deflector Cable
1. Slide compression spring (A, Figure 8) over rod and
insert into hole on chute deflector bracket.
2. Attach rod (B) to deflector post.
3. Attach remote deflector cable (C) to deflector post.
Secure with push nut (D).
NOTE: Before completing Step 4, make sure that the
chute deflector is in the full open position.
4. Route remote deflector cable (C) through slot in chute
deflector bracket. Secure with nuts (E) and washers
on either side of bracket.
5. Check remote deflector chute for proper operation.
Make adjustments as necessary.
ASSEMBLY
13
B
C
D
A
A
Figure 7
B
D
C
E
F
Figure 8