Lubrication -- Every 25 Hours - Craftsman C950-52850-0 Owner's Manual

LUBRICATION - - EVERY 25 HOURS
Chains
1. Position speed selector lever in first (1) forward gear.
2. Stand the snowthrower up on the auger housing end.
NOTE: When the crank case if filled with oil, do not
leave the snowthrower standing up on the auger
housing for an extended period of time.
3. Remove the bottom panel.
4. Lubricate the chains with a chain type lubricant.
Hexshaft-- wipe with 5W30 motor oil be-
fore storage and at the beginning of each
season.
CUSTOMER RESPONSIBILITIES
Chain
5. Wipe the hexshaft and sprockets with 5W30 motor oil.
NOTE: Clean all excess grease or oil found on the
rubber friction wheel or the disc drive plate.
CAUTION: Do not allow grease or oil to contact the
rubber friction wheel or the disc drive plate.
6. Install the bottom panel.
Chain
WARNING: If the disc drive plate or rubber
friction wheel come in contact with grease or
oil damage to rubber friction wheel will result.
If grease or oil come in contact with the disc drive
plate or friction wheel, make sure to clean the
plate and wheel thoroughly with a alcohol base
solvent.
25
Figure 20